Moulding · PU foam · 2K
Teping FL ST
PU system for pipe insulation shells
Two-component polyurethane system for pipe insulation shells, poured into press moulds automatically on high- and low-pressure machines.
- Thermal conductivity coefficient
- max. 0.035 W/(m·K)
- Cream time
- 20 – 40 s
- Dynamic viscosity at 25 °C
- 1,000 – 1,500 mPa·s
Overview
The product at a glance
Key points
- Pipe insulation shells
- Automatic pouring into press moulds
- Supplied with a polyisocyanate hardener
Where it is used
Purpose
- Used to make pipe insulation shells
Guides
Specifications
Technical data
Data from tnpgroup.ru. Check the application instructions before design.
- Components
- Two-component (2K)
- Base
- Polyurethane
- Dynamic viscosity at 25 °C
- 1,000 – 1,500 mPa·s
- Density of component A at 25 °C
- 1.0 – 1.2 g/cm³
- Cream time
- 20 – 40 s
- Gel time
- 60 – 120 s
- Core density
- at least 60 kg/m³
- Water absorption
- max. 10%
- Thermal conductivity coefficient
- max. 0.035 W/(m·K)
- Mix ratio by mass, component A : component B
- 100:140; 100:150
Product documents
Sent with the reply from a TNP technologist. Say in your enquiry which documents you need.
- Application instructions
- State registration certificate
Your expert
Natalia Markushina
Sales Manager · Polyurethane materials
Helps you choose a coating, sends the TDS and works out quantities. Write in whichever of these languages suits you.
Let us match a solution to your project
Tell us the area, substrate and service conditions. A TNP technologist will suggest a system and calculate quantities and delivery times.