Levelling screed · Cement
Teping Cem Universal
Self-levelling cement screed
One-component, polymer-modified, fast-drying mix for final levelling of concrete and sand-cement substrates 5–30 mm thick under parquet, tiles, seamless resins and resilient floor coverings. Walk-on after 3–4 hours.
- Layer thickness
- 5 – 30 mm
- Compressive strength (28 days)
- ≥ 40 MPa
- Walk-on after
- 3 – 4 h
- Consumption
- 1.8 kg/m² per 1 mm
Overview
The product at a glance
Key points
- Walk-on after 3–4 hours
- 1.8 kg/m² per 1 mm
- Suitable for underfloor heating
Where it is used
Facilities
- Apartments and offices
- Manufacturing
- Warehouses
- Car parks, garages
- Shopping centres
- Sports facilities
Purpose
- Final levelling of concrete and sand-cement substrates under parquet, tiles, seamless resins, textile and resilient floor coverings
- Must not be used without a protective or sealing topcoat
- Not suitable for slopes over 0.5 %
Specifications
Technical data
Data from the TNP technical data sheet. Check the application instructions before design.
- Layer thickness
- 5 – 30 mm
- Consumption
- 1.8 kg/m² per 1 mm
- Compressive strength (28 days)
- ≥ 40 MPa
- Flexural strength (28 days)
- ≥ 9 MPa
- Bond to concrete
- ≥ 1.5 MPa
- Frost resistance
- F200
- Water impermeability
- W12
- Abrasion
- ≤ 0.7 g/cm²
- Fire hazard class
- Non-combustible (NG)
- Working time
- ≤ 25 min
- Walk-on after
- 3 – 4 h
- Full load after
- 24 h
- Water per 25 kg bag
- 5.2 – 5.5 l
- Installation temperature
- +10 … +25 °C
Quantity for your project
Consumption 1.8 kg/m² per 1 mm of thickness. An estimate from the consumption in the technical data sheet, without allowance for the substrate or losses. A TNP technologist will calculate the exact quantity.
Which thickness to choose
- 5 – 15 mm
- Impermeable coating after 24 hours
- 15 – 30 mm
- Impermeable coating after 48 hours
Installation
How it is applied
- 1Surface preparationA substrate of at least 15 MPa and up to 5 % moisture is ground, milled or shot-blasted and vacuumed.
- 2PrimingPrime the substrate with Teping NG Primer AS, a highly absorbent one in two coats; lay the mix once the primer has fully dried.
- 3Preparing the mixAdd a 25 kg bag to 5.2–5.5 l of water, mix with a paddle for 2–3 minutes, then mix for another minute after a 2-minute pause.
- 4ApplicationPour onto the substrate, spread with a squeegee and roll with a spiked roller in two directions. Before an impermeable coating wait 24 hours for up to 15 mm and 48 hours for up to 30 mm.
Packaging and delivery
- Bag
- 25 kg
Product documents
Sent with the reply from a TNP technologist. Say in your enquiry which documents you need.
Your expert
Alexandra Antoshko
Head of Sales · Dry floor mixes
Helps you choose a coating, sends the TDS and works out quantities. Write in whichever of these languages suits you.
Let us match a solution to your project
Tell us the area, substrate and service conditions. A TNP technologist will suggest a system and calculate quantities and delivery times.